Es scheint kein Masterpasswort zu geben. Wenn du aber die Batterie entfernst und lange genug (am besten mehrere Tage) wartest, dürfte das Passwort draußen sein.
Dazu sagt Phoenix folgendes:
There is no "backdoor" password unless the computer manufacturer modified the BIOS to have one. The password is stored in
CMOS.
Take these steps:
1.First, enter into BIOS System Setup and record the settings.
2.Clear the CMOS (remove the CMOS battery until POST displays a "CMOS checksum bad" message)
3.Re-install the CMOS battery
4.Run the BIOS Setup program
5.Load default values by pressing F9 and set whatever configuration is needed.
NOTE: It can take several days for the CMOS to go bad without a battery. This is caused by capacitance in the circuit. This
charge can be safely discharged by using a 10k-ohm resistor, touched to the battery connectors for a few moments (while the
battery is removed). If this procedure does not work, the system manufacturer may have a procedure that does work.
Du kannst auch den Baustein selbst entfernen und warten. Ebenfalls kannst du (geht NUR bei Dallas-Uhren bestimmter Modelle) den Baustein in einer antistatischen Hülle ins Gefrierfach legen für ca. 2 Tage. DIES IST ABER DIE ALLERLETZTE MÖGLICHKEIT!!!!! DIES KANN SCHÄDEN ZUR FOLGE HABEN.
bye bye
no-1